With exceptional depth of colour and flattest possible chalk matte finish, Ultra Matte chalky is an interior designers dream for walls And woodwork. This high opacity chalky emulsion is ideally suited for walls and ceilings where you want your rooms to look simply exquisite. This lowest level of sheen helps to disguise minor imperfections, is wipeable and easy to touch-up.
For interior woodwork, walls and ceilings, the self-undercoating subtle effect complements beautifully our Ultra Matte. This finish was traditionally used on walls and ceilings where a higher level of durability or sheen was preferred. This still applies today, particularly if you’re looking for a contrasting sheen to combine with Ultra Matte. This eggshell paint is also ideal as an exterior masonry paint.
A beautifully smooth, pleasingly tactile, self-undercoating Satin paint suitable for most interior uses including woodwork such as doors, skirtings, floors and furniture, and suitably primed or previously painted metals such as radiators.
For interior walls and ceilings, this is a super-washable Matte paint. This finish is used on walls and ceilings where repeated washability & a higher level of durability is preferred, particularly for kitchens, bathrooms & areas for children & pets.
Linda Barker Paints are hand crafted using the finest natural ingredients. The water-based formulations are all powdered marble, bentonite clay, natural white pigment, mineral earth pigments, binder derived from natural gas and super-breathable, virtually odourless and have minimal VOC content. Key ingredients include clay kaolin powder, wood cellulose.
Surfaces should be clean, dry and free from grease & dust. Prime coat bare plaster/plasterboard with a Plaster Sealer. Woodwork - a light sanding is always beneficial.
Stir gently and thoroughly before use. Ideally apply 2 coats using a medium pile roller. DO NOT THIN. Do not paint in direct sunshine. Avoid temperatures below 5ºC or above 25ºC. Clean equipment with water.
With good ventilation - touch dry within 1 hour, a second coat can be applied after four hours.
On hard non-porous surfaces coverage is approx 10m2 per litre/coat.
Avoid contact with skin and eyes, wash off paint splashes with water. Keep out of reach of children. For full health and safety information see material safety data sheet available to download from the website. These products contain 0.1g/l VOC.
Clay kaolin powder, ground marble, bentonite clay, natural white & mineral earth pigments.
VOCs are compounds that easily become vapours or gases that can cause eye, nose and throat irritation, shortness of breath, headaches, fatigue, nausea, dizziness and skin problems. VOCs can be found in household products including some paints and cleaning products. Consumers may choose low VOC products to help minimise VOC levels inside their homes. Linda Barker Paints contain minimal levels of VOCs and are classified under Category A. Linda Barker Paints contain very low levels of VOCs at 0.1g VOC p/litre.